wire push to talk microphone to bookshelf stereo system

Insert the red wire into the red clip and the black wire into the black clip.

Spring Clips - If your receiver has spring clips, you will need to connect two wires for each speaker.

For some surround sound systems, the rear speaker inputs may be located on the subwoofer or a wireless receiver. The different speakers will usually have color-coded wires and inputs. Plug the cable from each speaker into the appropriately labeled input.

AV - If your speakers connect using an AV cable.

Use one of the following steps to connect the speakers to your receiver: Some receivers allow you to connect speakers using AV wire.

If your speaker wires are longer than 100 ft (30 m), use a thicker gauge to preserve the quality of the sound.Ĭonnect the speakers to the receiver.

If you need your speaker wires to reach further, replace them with a longer wire instead of extending them to get the best sound quality.

If this is the case, plug in the wireless receiver near the rear speakers and then connect the speakers to the wireless receiver.

Some newer surround sound systems use a wireless receiver to connect the rear speakers.

Make sure to leave some slack at each end to keep the wires from becoming stressed.

If you can, run the wires under the carpet or through the wall.

Do everything you can to hide your wires as you run them, as doing so will prevent people or animals from accidentally tripping on them and pulling your speakers.

In other cases, you will need to connect the wire to the speaker using an AV, spring clips, or binding posts.

In some cases, the wire may be permanently attached to the speaker.

Run wire from each speaker to the receiver.

Wire push to talk microphone to bookshelf stereo system